I N S T A L L A T I O N M A N U A L
B 0 9 U L F L I T H I U M B A T T E R Y
R e v . 1
© 2 0 1 9 D a r f o n E l e c t r o n i c s C o r p .
P a g e 1 1 o f 2 8
5.2
Before installation
This manual contains important information for the installation and safe operation of this product. Please follow the instructions
below before starting the installation:
•
Check whether the ambient temperature of the installation site is within the specified range of -10 °C to +45 °C; if the product
is working in the environment below 0 °C for a long time, the battery life will be reduced;
•
The area where the product is placed needs to be well ventilated, away from dangerous substances such as water,
flammable gases and corrosive agents; it is forbidden to install and operate in salt spray environment;
•
The product is prohibited from tilting or side-discharging, and the ventilation on both sides is good, leaving a heat dissipation
-bearing requirements of the battery
system;
•
Installation location should avoid sun, rain, snow, etc.;
•
Need to be installed by professionals;
•
If the product is disassembled or used under low temperature or high humidity, there may be condensation of water droplets.
It must be installed after the product is completely dry, otherwise there is danger of electric shock;
•
In any emergency, please stop charging and discharging immediately, and disconnect the circuit breaker;
•
All power outlets should be connected to the PGND cable.
5.2.1
Tool preparation
Lifting equipment
Phillips screwdriver
Slotted screwdriver
Insulated adjustable
wrench
Crystal head crimping
pliers
multimeter
Insulating protective
shoes
Insulating tape
Insulated gloves
Marker
Steel tape
Complete socket
wrench
Impact drill
rubber hammer
Crimping Tool
Wire stripper
Diagonal pliers
Utility knife
