Darex XT-3000, Operating Instructions Manual

Page: 10 / 36

10
Mounting Auto
Controller/
Display to
Base Casting:
1. Install and tighten
the two, 6mm BHSHC
screws from the stamped bracket to the control
box.
2. Align control box to main casting and transfer
punch or mark for drilling mounting screw holes.
3. Drill through
casting.
4. Using an alcohol wipe, thoroughly clean the
XT base casting surface where the adhesive will
make contact.
5. Peel adhe-
sive backing
from dual-lock
tape.
6. Carefully
align Controller/
Display to XT
base casting
and press
firmly.
5. Using 2, 10-24 thread forming screws,
insert into mounting bracket. While push-
ing hard, drive
in screws until
seated.
Automated Sharpening System