DAPAudio WCSS-230 G2, User Manual, Page: 24 / 28

23
WCSS-230 G2 WiFi Speaker
Product code: D6451
Selecting Equalizer Presets
You can select an equalizer preset.
Repeatedly press the EQ button to select an equalizer preset.
The order of the presets is as follows: Flat, Classical, Pop, Rock, Jazz, Enhanced vocals
Restoring Factory Settings
You can restore the default factory settings using the the function button (04) or the remote control.
To restore the default factory settings:
● Press and hold down the function button (04) for 10 seconds or,
● Press and hold down the RESET button on the remote control for 10 seconds.
The status LED indicator (02) shows:
LED color LED behavior Status
Red,
Green,
Blue
Flashing Updating/resetting the software
7. Troubleshooting
This troubleshooting guide contains solutions to problems which can be carried out by an ordinary
person. The device does not contain user-serviceable parts. Unauthorized modifications to the device will
render the warranty void. Such modifications may result in injuries and material damage. Refer servicing
to instructed or skilled persons. Contact your Highlite International dealer in case the solution is not
described in the table.
Problem Probable cause(s) Solution
The device does
not function at all
No power to the device
● Make sure that power is switched on and
cables are connected
No sound The volume is set to minimum ● Increase the volume of the signal source
The device cannot
connect to Wi-Fi
Wi-Fi network is offline
● Examine if the network works on another device
● Examine if the static IP address is configured
● Examine if your firewall does not block the
output ports
Wi-Fi signal is too weak
● Examine the distance between the device and
the router
● Move the device closer to the router
Incorrect Wi-Fi password ● Enter the correct Wi-Fi password
Playback stutters
(buffering)
Bandwidth is too low or busy ● Examine the internet connection
The device does
not respond to the
remote control
The remote control is outside
of the range of the sensor of
the infrared port ● Walk closer to the device or change the angle
at which you point the remote control at the
device. See 6.4. Remote Control on page 21
The battery in the remote
control is depleted
● Change the battery of the remote control
The device
responds erratically The factory settings of the
device are changed
Reset the parameters of the device to the
default factory settings. See 6.5. Restoring
Factory Settings on page 23