14
NRG-8
Product code: D3623
Overhead Suspension
CAUTION
Restrict the access under the work area during installation and/or deinstallation.
You can suspended the device on an overhead structure from the 3 rigging points with rigging eyes. See
3.5. Optional Accessories on page 10.
To suspend the device, follow the steps below:
Use a hex key to remove the 3 hex screws from
the 3 mounting openings (01).
Fig. 08
Note:
It is recommended to use a fender washer under
the rigging eye to distribute the load on the
enclosure.
Insert the rigging eyes in the 3 mounting
openings (01).
Turn the rigging eyes clockwise to tighten
them.
Fig. 09
Make sure that the rigging eyes are fully
seated and oriented in the plane of pull.
Suspend the device on the overhead structure
with suitable suspension cables/chains.
Note:
If the rigging eyes are removed, reinstall the hex
screws in the 3 mounting openings (01). If the
screws are not installed in the 3 mounting openings
(01), air leaks occur in the enclosure. This results in
undesirable performance of the device.
Fig. 10
Summary of Contents for NRG-8
Page 24: ...2023 DAP...