9
DCP-26
Productcode: D2084
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Install this device on a flat surface, not bend or curved.
Do not supply power before all components of the system are set up and connected properly.
Make sure to power-up your DCP-26 before your power amplifiers are switched on in order to avoid loud
transients, which could damage your speakers or annoy your audience.
System test
After connecting all cables, you should run a system test. Press all Mute-buttons in order to mute all
outputs. Activate the HF-outputs first. In case of wrong cabling, High Frequency (HF) audio signals will
come out of bass-speakers that cannot be harmed this way. Vice versa, the Low Frequency (LF) audio
signals would destroy your HF-speakers.
Input setup
Push the Channel Up button to select the channel you wish to edit. In the example below, input channel
A is selected.
Adjust the gain by dialing the
jogwheel
(8)
. Push the
item up (2)
button to proceed with the next item. In
our example the Lowpass filter.
Adjust by dialing the
jogwheel
(8)
. You can switch the lowpass filter off by dialing the
jogwheel
(8)
clockwise until the frequency passes 20kHz. Click the
jogwheel
(8)
to change the filter type.
Select the type by dialing the
jogwheel
(8)
. You can choose from: But(terworth) 6dB, Bes(sel) 6dB,
But(terworth) 12dB, Bes(sel) 12dB, L(inkwitz) R(iley)12dB, But(terworth) 18dB, Bes(sel) 18dB, But(terworth)
24dB and Bes(sel) 24dB. Once selected the correct filter type, click the
jogwheel
(8)
to return to the
lowpass filter frequency (for (re)adjusting) or push the
item up (2)
button to proceed with the next item, in
our example, the Highpass filter.
InA Gain
11.75dB
InA LowPass
freq: 19600hz
InA LowPass
Type: but 6db
InA HighPass
Freq: Off
Summary of Contents for DCP-26
Page 35: ...34 DCP 26 Productcode D2084 Notes...
Page 36: ...2013 DAP Audio...
