7
Ordercode: D3902
Odin S-218A Ultra Sub
Installation
Remove all packing materials from the Odin S-218A Ultra Sub. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Connection Example
Make your initial connections with all the equipment powered off and ensure that all the main volume
controls are turned completely to the minimum. Follow the steps below. See Fig. 03 for more information.
01)
Connect one end of the XLR cable to your audio mixer (to MAIN OUT MONO) and the other end of
the cable to the audio signal input (03) on your speaker.
02)
Using an XLR cable, connect the audio signal link (02) on your first speaker to the audio signal input
(03) on your second speaker. Repeat this step to connect multiple speakers.
03)
Using a PowerCON power cord, connect the speaker’s power input (07) to the power supply.
Please note, that it is allowed to connect only 1 speaker per phase (16A).
04)
In order to enable data signal reception, connect the CL-4 Connect (D3915) to the first speaker’s
RJ45 data input (04), using a UTP/CAT-5 cable. Connect the first speaker’s data link (05) to the
second speaker’s data input (04). Repeat this step to connect multiple speakers. Please note, that to
ensure proper data reception, it is allowed to connect up to 12 speakers.
05)
Use the PFL function to get the proper input level for the mixer and adjust the Main Mix Level.
06)
After using your equipment, turn off your active speaker cabinets first, then the mixer.
Fig. 03
Summary of Contents for D3902
Page 12: ... 2019 ODIN ...
