DAPAudio D2287, Manual

Page: 15 / 24

14
GIG-164CFX
Order code: D2287
Backside
60. IEC POWER INLET
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, and then turn on the POWER (61) switch to operate
the unit.
61. POWER ON/OFF
Do not supply power before the whole system is set up and connected properly.
62. +48V POWER SWITCH
Press this button to turn the phantom power +48V on. Do not connect any unbalanced microphones with
the phantom power switched on. The red Phantom LED (35) will light if the phantom power is activated.
63. USB PORT
This USB port can be used to connect the GIG-164CFX to your PC/ laptop. You can use this connector for
playback or record with your favorite media player.
64. MAIN MIX OUTPUT
Balanced XLR male connectors and provide the MAIN MIX signal.
65. STEREO (MAIN) OUTPUT
Unbalanced ¼" stereo jacks and provide the MAIN MIX signal.
66. MAIN INSERT
This is where you connect serial effects before the MAIN MIX fader control. These serial effects usually are
compressors or equalizers. The send signal is low-impedance, capable of driving any line-level device.
The return signal is high impedance and can be driven by almost any device. Use dedicated “Y” cables
to connect external effect devices.
67. FX OUT OUTPUT
The FX OUT OUTPUT provides the signal of the internal effects.
68. FOOT SWITCH
This socket is used to connect an external foot switch. It has the same function as the FX MUTE switch (40).
69. STEREO CONTROL ROOM OUTPUTS
The CONTROL ROOM OUTPUTS ( unbalanced ¼" stereo jacks ) are used to send the signal to studio monitor
speakers.
70. GR 1-2/3-4 OUT
The GR1-2 or GR 3-4 send outputs ( unbalanced ¼" stereo jacks ) provide the signals of the GR 1-2 or
GR 3-4 bus.
71. AUX SEND 1, 2, 3, 4
The AUX send outputs ( unbalanced ¼" stereo jacks ) provides the signal of the AUX bus.