DAP Technology 1394, Operation Manual

Page: 208 / 458

Filter/Trigger
208 Copyright © DapTechnology B.V., 2005-2019 - All Rights Reserved., 5/20/2019
In the Skip events box you can select which events should be skipped by checking the corresponding
checkboxes. By default all the 'Bus Reset' events will be skipped.
Note that Bus-Reset events can not be skipped.
12.1.4. Packet Sets
The Packet Sets tab is not available on
·
Stealth Series in Symbol Recorder mode
Header and data fields are limited to the "==" operation for the condition field on the following device
types:
·
Third Generation Analyzers
An example of a page of one of the four basic packet sets is shown below. Here you can define the
condition of the packets that fits the set.
First of all, you can select between Primary Packets or Phy Packets. When Primary Packets are selected,
you can select which primary types may fit the set by checking the corresponding checkboxes inside the
Primary Packets box. In the example below only Write Block Request and Read Block Response packets
will fit the set. Inside this box there are also some buttons to make a quick selection of some types. Using
the with Data block button for instance you can select the packet types that have an associated data
block.
Using the checkboxes inside the Packet Speeds box, you can include or exclude packets by their packet
speed. By default all speeds will fit the set