Dantherm HRV 5, Service Manual

Page: 26 / 158

24
How to set temperature setpoints
Introduction This section describes how to set the following
temperature setpoints .

Temperature for heating (T
min
)
(electric heating element is accessory)

Temperature for summer mode (T
max
)
Setpoints are described in the section ” Set-
points
” on page 14
Display shows that the menu ”setpoints” is activated
This example shows T
min
:
NB The difference between T
min
and T
max
can never be less than 5 degrees. This will avoid
inconvenient situations where the unit is trying to heat and cool at the same time.
Procedure Follow this procedure to set temperature setpoints:
Step Action Result
1 Follow the procedure for activating the remote
controller and menu in the section ”How to
use the remote controller
” page 22
The selected menu is acti-
vated
2 Press UP/DOWN buttons to set T
min
Temperature. (Only relevant if the unit is fitted
with an electric heating element)
The temperature digits
change
3 Press OK
”T
max
” flashes
4 Press UP/DOWN button and set T
max
temper-
ature
The temperature digits
change
5 Confirm by pressing OK
The display returns to ”nor-
mal screen” again