Dantherm CC 3000, Service Manual, Page: 18 / 40

18
Installation : External Connections
The terminal rails J.33 and J.1 are to be used for connecting up to two free cooling units.
• Terminal type: Anytek KE161151A000G (Mating type Anytek KD161050A000G).
Pin J .33
Flexibox 1
J .1
Flexibox 2 Cable type
1 +48 V supply
(40-60 V DC from free cooling unit) 0,5 mm
2
2 PWM
3 Tacho
4 GND
5 Filter
6 GND
7 Outdoor temp. sensor
8 GND
The terminal rails J.13 and J.2 are to be used for connecting up to two motorized dampers.
• Terminal type: Anytek KE061151A000G (Mating type Anytek KD061050A000G).
Pin J .13
Damper 2
J .2
Damper 1 Cable type
1 Closed signal 0,5 mm
2
2 Open signal
3 Common (fused)
The terminal rails J.9 and J.4 are to be used for connecting up to two air conditioner.
• Terminal type: Anytek KE061151A000G (Mating type Anytek KD061050A000G).
Pin J .9
A/C 1
J .4
A/C 2 Cable type
1 24 V AC - 100 mA.
Output can be configured as dry contact or 0/24 V DC output.
For 0/24 V DC output, a jumper on PCB must be set (see page 14).
0,5 mm
2
2 0/24 V DC
3 GND
The terminal rails J.40 and J.3 contain 10 dry contacts for the alarm output, fully configurable.
• Terminal type: Anytek KE201151A000G (Mating type Anytek KD201050A000G).
Pin J .40
Alarm 1-5
J .3
Alarm 6-10 Cable
type
1 Alarm 1
•
mechanical relay with NO/NC contact
Alarm 6
•
solid state type: NO contact
0,5 mm
2
2
3
Alarm 2
•
mechanical relay with NO/NC contact
Alarm 7
•
solid state type: NO contact
4
5
Alarm 3
•
solid state type: NO contact
Alarm 8
•
solid state type: NO contact
6
7
Alarm 4
•
solid state type: NO contact
Alarm 9
•
solid state type: NO contact
8
9
Alarm 5
•
solid state type: NO contact
Alarm 10
•
solid state type: NO contact
10
Free cooling units
(Fig . 10)
Motorized
dampers
(Fig . 10)
Air Conditioner
(Fig . 10)
Alarm
(Fig . 10)