P
AGE
18
46020-38-0299 <90-00029>
SWITCH SETTINGS
T
he tables in this section refer to Fig. 12, which represents
the way the switches look when the module is viewed from
the top, with the front panel of the MAP on the right side.
F
IG
. 12 - 46020 MAP V
IEWED
FROM
THE
T
OP
S
WITCH
S1 - TBOS D
ISPLAYS
AND
N
UMBER
OF
MAC
S
This switch allows you to define:
♦
The number of 46022-1X Multiple Alarm Combiners (MACs)
with switches S1-7 and S1-8. Refer to Table A for switch set-
tings.
If you use discrete points and/or TBOS serial ports, the MAP
data port communicates through MACs. Each MAC has eight
communication ports.
Use one port for each location. A serial port can handle from
one to eight TBOS displays, so if more than eight displays
come from a location you may need more than one port at
that location.
MAC and display limitations for protocols set with switch
S2 are:
TBOS/Printer -
The maximum number of MACs is one.
This protocol is limited to a maximum of eight displays.
TBOS/TBOS -
The maximum number of MACs is two.
This protocol is limited to a maximum of eight displays.
DCP/Printer or DCP/DCP -
The maximum number of
MACs is four. These protocols are limited to a maximum
of 32 displays.
♦
TBOS displays per port using switches S1-1 to S1-6. Refer to
Table A for switch settings.
N
OTE
:
If you use a combination of serial
ports and discrete points, all dis-
crete points go through the first
port of the first MAC. There is no
limit on the number of discretes
that can go through the first
port. The combined total of TBOS
displays and discrete points (con-
verted to equivalent TBOS dis-
plays of four MATs and four
CPMs which equal one display)
cannot exceed the protocol limits
described above.
VIEW
ROTATED
90 DEGREES
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
SWITCH 1
SWITCH 2
SWITCH 3
SWITCH 4
UP = OFF
DOWN = ON
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
S5
S6
S7
1 2 3 4 5 6 7 8
SWITCH 5
