Page
12
of
28
CONFIG MODE
The Beatrice B1 and B2 have a configuration mode that allows the user to adjust
certain settings and parameters of the device.
To enter config mode, the UPDATE button on the left side panel must be held down
for 3 seconds.
Config mode is linear, where settings are changed in groups that are cycled through.
Once config mode is entered, the LEDs will rapidly flash to indicate which group of
the config mode the device is currently in. To cycle through to the next group, simply
press the UPDATE button once.
Note: In config mode, audio from the Microphone input is only transmitted to Dante
during group one (where mic gain is adjusted), regardless of the talk switch position
or party mode status.
Audio from Dante is not silenced and continues as normal whilst in config mode.
1. Power LED and Call LED flash
– Mic gain and Phantom power control
In this first config mode, turning pot one will adjust the Microphone gain, whilst
pressing the talk switch will 12v phantom power on or off.
On the B2 this is done by pressing both talk switches at the same time.
The Red/Green LED
“Mic” LED will illuminate to indicate mic gain level. Green
is acceptable level, orange indicates that the level is a little high and red
indicates close to overloading the input and clipping.
2. Call LED flashes - Sidetone and call chime level
In the second config mode, activating talk switch one will allow adjustment of
the call alert tone and the call send tone by turning pot one.
Group one
–
Mic gain and Phantom power
Group two
–
Sidetone and call level
Group three
–
Headphone pan control &
Headphone end stop level
Group four
–
Party mode toggle
UPDATE button