Copyright 2005
28
Vulcan V SERIES
Owner’s Manual
Canadian Comfort Industries
www.stovesunlimited.com
Dansons Group Inc.
CLEANING YOUR SUPER GRATE
INSERTING, REMOVING & ADJUSTING THE BURN GRATE
The burn grate top, (D), must fit and seal firmly on the upper lips, of the burn box, (A). An
improper seal will allow incoming combustion air to escape, not passing up through the burn
grate thus reducing the amount of combustion air in the area needed to efficiently burn pellets.
A
Burn Box
-Combustion air is brought into the backside
and through the burn grate bottom, back and
front
- Check periodically for fly ash build up
B “SUPER
GRATE”
-Stainless steel construction, slotted bottom
and air holes on front and back
-Slotted hole for Igniter air flow
C Adjustment
Tab
-Used to fine tune and level burn grate
D
Super Grate Upper Lip
Adjust the burn grate top so that the burn grate top sits firmly on the top of
the burn box and level.
Removal of burn grate top:
(1)Lift upward while sliding lip out from
under lip of slide
(2)Then pull out toward outside of burn box
(3) Installation is reverse of this.
Grasp the burn grate adjustment tab, with a pair of pliers and bend it
slightly to left or right (and re-install into burn box) until its length
allows the burn grate top to rest tightly onto the burn grate bottom
B
C
D
A
Summary of Contents for CC2
Page 1: ......
