1
IEEE 802.3 10Mbps Ethernet
TP-Fiber Converter — CEM1500
TP-BNC Converter
— CEM0100
User’s Manual
(620-0012-000)
1. Overview
IEEE 802.3 10Mbps Ethernet supports various type media for network connection such as 10Base-
2, 10Base-T, and 10Base-FL. The media converter is used to convert one type media signal to
other type equivalent that allows multiple type segments connect easily and inexpensively. The
converter can be used as a standalone unit or as a slide-in module to the 19” converter rack (up
to 10 units) for use at a central wiring closet.
10Mbps CEM0100 Converter Front and Side Panel
2. Model
Description
Model
Connector Type
CEM1500
RJ-45
↔
850nm ST Multi-mode
CEM0100
RJ-45
↔
BNC
4. Installing the Converter
For as a standalone unit:
⇒
Verify the AC-DC adapter conforms to your country AC power requirement and insert the
power plug
3. Checklist
⇒
Connect the media cable for network connection
Before you start installing the Converter, verify that the package contains the following:
For as a slide-in unit:
—
The Converter
⇒
The slide-in Media Converter and Converter Rack should be supplied only from the same
source, both Media Converter and Rack are built to match each other at dimensions, DC
jack, DC receptacle and power safety
—
AC-DC Power Adapter
—
This User’s Manual
—
T-Connector (for TP-BNC Converter model only)
⇒
Turn off the 19” converter rack power
Please notify your sales representative immediately if any of the aforementioned items is missing
or damaged.
⇒
Ensure that there is no activity in the network
⇒
5V DC power jack on converter back, carefully slide in and plug to 19” rack +5V DC
power receptacle
⇒
Connect the media cable for network connection
⇒
Turn on the converter rack power, the Power LED will light up
10Mbps CEM1500 Fiber Converter Front and Side Panel
Fiber Port
Attach the fiber cable. The Tx, Rx fiber cable must be paired at both ends.
Attach TP Cat. 3 or Cat. 5 cable to TP port
MPR: To a Hub or Repeater
DTE: To a workstation or NIC
TP Port
Slide switch “DTE”/”MPR” is on the side panel. Default: MPR
BNC Port
Attach T-Connector to BNC port and connect the RG-58A/U coaxial network.
Ensure the coaxial cable/segment is terminated at both ends properly.
Note:
a.
Use the straight-through cable.
Cable pin-outs for RJ-45 jack 1, 2, 3, 6 to 1, 2, 3, 6
b.
MPR (Default) : To a Hub or a Repeater
DTE
: To a workstation or Network Interface Card (NIC)
(DTE pin-outs is crossover on board already)
Configure the MPR-DTE slide switch on the side panel for cable connection to hub or
Network Interface Card (NIC)
5. Connecting to 10/100Mbps N-Way Device
Converter Model
10/100 N-Way Inter-operating
TP-Fiber Converter
10/100Mbps is auto-sensing and comes to 10Mbps Half-duplex
TP-BNC Converter
10/100Mbps is auto-sensing and comes to 10Mbps Half-duplex