![background image](http://html1.mh-extra.com/html/dannmar/mb-240x/mb-240x_installation-and-operation-manual_3431293023.webp)
MB-240X Wheel Balancer
23
P/N 5900262 — Rev. A1 — Jan. 2021
Operation
This section describes how to use your MB-240X Wheel Balancer.
About the MB-240X Wheel Balancer
The MB-240X has no motor to drive the Tire
and Wheel. Instead, the Wheel is rotated by
hand-spinning the Quick Nut. The black
handles of the Quick Nut rotate freely and will
allow you to easily develop the speed (≈180
rpm) required to balance the Wheel.
Usage Precautions
Keep the following in mind while you operate
your Balancer:
•
Make a visual inspection of the balancer
before each use
. Do not operate your Balancer if you find any issues. Instead, take the unit out
of service, then contact your dealer, visit
, or call
(877) 432-6627
.
•
Keep the work area clean and well lit. Dirty, cluttered, and dark work areas increase the chances of
an accident happening.
•
Do not remove the Storage Tray unless instructed to do so by Dannmar Support. There are no
user serviceable parts underneath.
•
When using the product, you
must
wear appropriate work clothing: leather gloves, non-skid steel-
toed work boots, and an industrial back belt. Keep hair, jewelry, and clothing away from the unit.
•
When using the product,
the operator must wear ANSI-approved eye protection at all
times
: safety glasses, a face shield, or protective goggles.
⚠
WARNING
Always wear ANSI-approved eye protection. Although rare, an accident could
cause significant injuries to your eyes.
⚠
WARNING
Do
not
attempt to stop a rotating Wheel with your hands. Always use the brake.
Even though there is no motor driving the Wheel, it can severely injure you if it is in
motion.
•
Only authorized personnel may use the unit. Keep children and untrained personnel away.
•
Do not use the unit in a wet environment or expose it to rain.
•
If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment must be used. Cords rated for less current than the equipment may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
•
Do not use the unit in the vicinity of open containers of flammable liquids.
•
Clean the unit according to the instructions in the
section.
•
Read the entire
Installation and Operation Manual
before using the Wheel Balancer.
Summary of Contents for MB-240X
