Dannmar MB-240X, Installation And Operation Manual, Page: 15 / 60

MB-240X Wheel Balancer
15
P/N 5900262 — Rev. A1 — Jan. 2021
Anchoring the Optional Balancer Mounting Stand
The optional Balancer Mounting Stand has three placement points for Anchor Bolts, which hold the
Balancer in place while in use.
Top View. Not to scale. Not all components shown.
Important : You are
required
to bolt your Balancer into place, as Balancer movement during a
Wheel Balance can result in inaccurate test results.
To anchor the Balancer :
Move the Balancer to the desired location. Flat concrete provides the best mounting surface.
Remember that you need to allow some space around the Balancer. Refer to
Finding a
Location for additional information.
Using the holes in the Mounting Stand as guides, drill the holes for the M10 x 59 mm Anchor Bolts.
Go in straight; do not let the drill wobble. Use a carbide bit (conforming to ANSI B212.15).
The diameter of the drill bit must be the same as the diameter of the Anchor Bolt. So if you are
using an M10 diameter Anchor Bolt, for example, use an M10 diameter drill bit.