Dannmar D4-9, Installation And Operation Manual

Page: 66 / 85

D4-9 / D4-9X Four-Post Lifts
66
P/N 5900251 — Rev. A1— August 2021
Maintenance
⚠
DANGER Before performing maintenance on your Lift, make sure it is disconnected from
power. The Lift uses electrical energy; if your organization has Lockout/Tagout
policies, make sure to implement them
before performing any maintenance. If you
come into contact with high voltage/current, you could be injured or killed.
If you need to replace worn, damaged, or broken parts, you must use parts from (or approved by) the
original equipment manufacturer (OEM) or parts that meet the OEM’s specifications.
⚠
WARNING If you use parts not from, approved by, or meeting the specifications of the original
equipment manufacturer, you void your warranty and compromise the safety of
everyone who installs or uses the Lift.
To maintain your Lift :
• Daily : Keep the Lift clean. Wipe up any spills, clean any dirt.
• Daily : Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before using the Lift.
⚠
DANGER
Do not use the Lift if the Lifting Cables are damaged or extremely worn. If a Vehicle
is raised when you notice the damage or extreme wear, very carefully lower the
Vehicle to the ground if this can be done safely; if it cannot be done safely,
evacuate the area and make arrangements with trained lift service personnel to
lower the Vehicle. When the Lift is on the ground, take it out of service, disconnect
it from power, and make arrangements with trained lift service personnel to fix the
damage and/or wear.
• Daily : Make sure all Safety Locks are in good operating condition. Do not use your Lift if the
Safety Locks are damaged or excessively worn. If a Vehicle is engaged on its Safety Locks when
damage or excessive wear is noticed, and the Vehicle cannot be lowered, evacuate the area and
make arrangements with trained Lift service personnel to come and lower the Lift.
• Monthly : Check all labels on the Lift. Replace them if they are illegible or missing.
•
Monthly
: Grease the Cable Sheaves on the Lift. Use white lithium grease or similar.
•
Monthly
: Check Hydraulic Fluid levels. Refill if low.
• Monthly : Lubricate the wire rope (Lifting Cables). Use a wire-rope lubricant such as 90-WT gear
oil or ALMASOL® Wire Rope Lubricant.
• Monthly : Check cable connections, bolts, and pins for proper mounting and torque.
• Monthly : Check electrical connections. Requires a licensed, certified Electrician.
• Every two months : Check all Anchor Bolts to make sure they are properly torqued (if your Lift is
anchored). If they are loose, tighten them.
⚠
WARNING
Do not operate your Lift if you find maintenance issues; instead, take the Lift out of
service, then contact your dealer, trained lift service personnel, visit
dannmar.com/support , email support@dannmar.com , or call
(877) 432-6627 .