Danfoss VLT OneGearDrive, Operating Manual

Page: 27 / 44

1.
2.
3.
4.
1.
2.
3.
4.
-
-
-
Table 15: Oil Volume
P1
(1)
P2 P3
Oil volume [l (fl oz)] 2.2 (74.4) 3.1 (105)
1 P1 is no longer available in the Danfoss DRIVECAT configurator. Use P2 also for P1 installations.
8.5.4 Changing the Oil
N O T I C E
DANGER OF BURNS
The surface of the VLT® OneGearDrive® and the oil in the VLT® OneGearDrive® can reach high temperatures during operation.
Do not touch the VLT® OneGearDrive® until it has cooled down.
Do not carry out an oil change until the oil has cooled sufficiently.
8.5.4.1 Draining the Oil
1
2
e30bc424.10
Illustration 13: VLT® OneGearDrive® Oil Screws 1 and 2
Procedure
Once the VLT® OneGearDrive® and the oil have cooled down, remove the VLT® OneGearDrive® from the system.
Bring the VLT® OneGearDrive® into a vertical position and remove oil screws [1] and [2].
Turn the VLT® OneGearDrive® into a horizontal position and drain the oil through screw hole [1] into a suitable container.
Turn the VLT® OneGearDrive® back into a vertical position.
8.5.4.2 Filling the Oil
N O T I C E
The required oil quantities can be found on the nameplate and in 8.5.3 Oil Volume .
Procedure
Fill the VLT® OneGearDrive® with the appropriate amount of oil through screw hole [1].
Check that the oil level is correct using the oil dipstick supplied with the optional oil check service kit
Remove all traces of oil from the surface of the VLT® OneGearDrive® using a soft cloth.
Reinsert and tighten oil screws [1] and [2] with tightening torque 7 Nm (61.96 in-lb).
8.6 Spare Parts
Contact the local Danfoss sales company for information on spare parts.
AQ347551551757en-000101 / 130R0239 | 27 Danfoss A/S © 2020.12
Maintenance, Decommissioning,
and Disposal
VLT® OneGearDrive®
Operating Guide