![Danfoss VLT OneGearDrive Instruction Manual Download Page 12](http://html1.mh-extra.com/html/danfoss/vlt-onegeardrive/vlt-onegeardrive_instruction-manual_3531470012.webp)
max 0.2 mm
130BD764.10
Figure 3.4 Maximum Allowed Eccentricity of the Conveyor Shaft
Type
Dimensions [inch]
Shaft
Disc
a
b
min
b
max
c
d
e
f
1)
g
h
i
k
l
m
n
o
p
OGD-L1 1.250
4.724 5.512 0.250 0.138 0.195 5.122
+0.02
0.500-13
[M12]
0.866 1.181 0.118 0.059 1.496 0.1575 1.236 0.512
OGD-L2 1.4375 4.724 5.512 0.375 0.214 0.195 5.122
+0.02
0.500-13
[M12]
1.102 1.457 0.118 0.059 1.693 0.1575 1.425 0.512
OGD-L3 1.500
4.724 5.512 0.375 0.211 0.195 5.122
+0.02
0.625-11
[M16]
1.417 1.772 0.118 0.079 1.890 0.1575 1.488 0.669
Table 3.3 Dimensions of the Shaft and Disc
1) Key length required for b
min
. Adapt the key length according to the shaft length used (b).
The dimensions shown could differ from the customer conditions and must potentially be changed by the customer.
NOTICE!
Use grease to mount the OneGearDrive onto the shaft. For example, CASTROL Obeen Paste NH1, ARAL Noco Fluid or
similar. Use a key in the same material and quality as the hollow shaft.
3.7 Torque Restraint
The OneGearDrive requires a suitable torque restraint to resist the reaction torque. The torque arm with mounting set is
available as an option (see
). Ensure that the torque arm does not create excessive constraining
forces, for example, due to the driven shaft running untrue. Excessive backlash can result in excessive shock torques in
switching or reversing operations.
Mechanical Installation
Instruction Manual
10
Danfoss A/S © 08/2014 All rights reserved.
MG75C422
3
3