5 Installation/Fitting
5.1 Transport and Delivery
5.1.1 Scope of Delivery
The scope of delivery of the ISD 410 servomotor
comprises:
•
The servomotor
•
These operating instructions
•
An installation tool for threaded cable connectors
130BC483.10
Illustration 5.1 Installation Tool for Threaded Cable Connectors
The packaging unit depends on the number of delivered
servomotors. However, operating instructions and an
installation tool for threaded cable connectors is supplied
for each servomotor.
Save the packaging for use in the event of product return.
5.1.2 Transport
The maximum weight of an individual package is approxi-
mately 7 kg. Note:
•
Always use means of transport and lifting gear
with sufficient load capacity to transport motors
•
Avoid vibration during transport of motors
•
Avoid heavy impacts and blows
5.1.3 Inspection on Receipt
After receiving the delivery, immediately check whether
the scope of delivery matches the shipping documents.
Danfoss will not honour claims for faults registered at a
later time.
Register a complaint immediately:
•
with the carrier in case of visible transport
damage;
•
with the responsible Danfoss representative in
case of visible defects or incomplete delivery.
5.2 Safety Measures during Installation
Always observe the safety instructions in
during installation.
Pay particular attention to ensuring that the following
points are observed carefully:
•
Installation may only be performed by qualified
staff.
•
Installation must be performed with due care and
attention.
•
All safety regulations and protective measures are
complied with, and the environmental conditions
are observed.
•
The documentation is read and understood.
5.3 Installation Environment
Environmental Conditions
The installation must provide the following environmental
conditions to allow the servomotors to be operated safely
and efficiently.
•
The allowable operating ambient temperature
range is not exceeded.
•
The relative humidity is ≤ 85%, non-condensing.
•
The vibration level is ≤ 2 g/20 m/s2 without
resonance excitation.
•
Unrestricted ventilation is available.
•
The mounting structure is suitable for the
application, adequately rigid, etc.
Contact Danfoss if it is not possible to comply with these
environmental conditions.
Installation/Fitting
VLT
®
ISD 410 Servomotor Operating Instructions
MG75D102 - VLT
®
is a registered Danfoss trademark
21
5
5
