Danfoss VLT HVAC Series, Programming Manual, Page: 176 / 338

16-05 Main Actual Value [%]
Range: Function:
0.00 %* [-100.00 - 100.00 %] View the two-byte word sent with the status word to the bus master reporting the main actual value.
16-09 Custom Readout
Range: Function:
0.00 Cus-
tomReadou-
tUnit* [-999999.99 - 999999.99 Custom-
ReadoutUnit] View the user-defined readouts as defined in par.0-30 Custom Readout Unit , par.0-31 Custom
Readout Min Value and par.0-32 Custom Readout Max Value .
3.16.3 16-1* Motor Status
Parameters for reading the motor status values.
16-10 Power [kW]
Range: Function:
0.00 kW* [0.00 - 1000.00 kW] View the motor power in kW. The value shown is calculated on the basis of the actual motor voltage
and motor current. The value is filtered, and therefore approx. 30 ms may pass from when an input
value changes to when the data readout values change.
16-11 Power [hp]
Range: Function:
0.00 hp* [0.00 - 1000.00 hp] View the motor power in HP. The value shown is calculated on the basis of the actual motor voltage
and motor current. The value is filtered, and therefore approximately 30 ms may pass from when
an input value changes to when the data readout values change.
16-12 Motor voltage
Range: Function:
0.0 V* [0.0 - 6000.0 V] View the motor voltage, a calculated value used for controlling the motor.
16-13 Frequency
Range: Function:
0.0 Hz* [0.0 - 6500.0 Hz] View the motor frequency, without resonance dampening.
16-14 Motor Current
Range: Function:
0.00 A* [0.00 - 1856.00 A] View the motor current measured as a mean value, IRMS. The value is filtered, and thus approxi-
mately 30 ms may pass from when an input value changes to when the data readout values change.
16-15 Frequency [%]
Range: Function:
0.00 %* [-100.00 - 100.00 %]
3 Parameter Description VLT ® HVAC Drive Programming Guide
3-152
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
3