Danfoss VLT HVAC Drive FC 100 Series, Programming Manual, Page: 112 / 122

5.1.12 15-** Drive Information
Par.
No. # Parameter description Default value 2-set-up Change
during
operation
Conver-
sion index
Type
15-0* Operating Data
15-00 Operating hours
0 h 1 set-up TRUE 74 Uint32
15-01 Running Hours 0 h 1 set-up TRUE 74 Uint32
15-02 kWh Counter 0 kWh 1 set-up TRUE 75 Uint32
15-03 Power Up's 0 N/A 1 set-up TRUE 0 Uint32
15-04 Over Temp's 0 N/A 1 set-up TRUE 0 Uint16
15-05 Over Volt's 0 N/A 1 set-up TRUE 0 Uint16
15-06 Reset kWh Counter [0] Do not reset 1 set-up TRUE - Uint8
15-07 Reset Running Hours Counter [0] Do not reset 1 set-up TRUE - Uint8
15-3* Alarm Log
15-30 Alarm Log: Error Code
0 N/A 1 set-up TRUE 0 Uint8
15-31 InternalFaultReason 0 N/A 1 set-up TRUE 0 Int16
15-4* Drive Identification
15-40 FC Type
0 N/A 1 set-up FALSE 0 VisStr[6]
15-41 Power Section 0 N/A 1 set-up FALSE 0 VisStr[20]
15-42 Voltage 0 N/A 1 set-up FALSE 0 VisStr[20]
15-43 Software Version 0 N/A 1 set-up FALSE 0 VisStr[20]
15-44 Ordered TypeCode 0 N/A 1 set-up FALSE 0 VisStr[40]
15-46 Drive Ordering No 0 N/A 1 set-up FALSE 0 VisStr[8]
15-47 Power Card Ordering No 0 N/A 1 set-up FALSE 0 VisStr[8]
15-48 LCP Id No 0 N/A 1 set-up FALSE 0 VisStr[21]
15-49 SW ID Control Card 0 N/A 1 set-up FALSE 0 VisStr[21]
15-50 SW ID Power Card 0 N/A 1 set-up FALSE 0 VisStr[21]
15-51 Drive Serial Number 0 N/A 1 set-up FALSE 0 VisStr[10]
15-53 Power Card Serial Number 0 N/A 1 set-up FALSE 0 VisStr[20]
15-9* Parameter Info
15-92 Defined Parameters
0 N/A 1 set-up TRUE 0 Uint16
15-97 Application Type 0 N/A 1 set-up TRUE 0 Uint32
15-98 Drive Identification 0 N/A 1 set-up FALSE 0 VisStr[40]
Table 5.13
Parameter Lists
VLT
®
HVAC Basic Drive Programming Guide
5-12 MG18B222 - VLT
®
is a registered Danfoss trademark
5 5