Danfoss VLT HVAC Drive FC 100 Series, Programming Manual, Page: 105 / 122

5.1.5 3-** Reference/Ramps
Par.
No. # Parameter description Default value 2-set-up Change
during
operation
Conver-
sion index
Type
3-0* Reference Limits
3-02
Minimum Reference 0 ReferenceFeedbackUnit All set-ups TRUE -3 Int32
3-03 Maximum Reference ExpressionLimit All set-ups TRUE -3 Int32
3-1* References
3-10
Preset Reference 0 % All set-ups TRUE -2 Int16
3-11 Jog Speed [Hz] 5 Hz All set-ups TRUE -1 Uint16
3-14 Preset Relative Reference 0 % All set-ups TRUE -2 Int16
3-15 Reference 1 Source [1] Analog in 53 All set-ups TRUE - Uint8
3-16 Reference 2 Source [2] Analog in 54 All set-ups TRUE - Uint8
3-17 Reference 3 Source [11] Local bus reference All set-ups TRUE - Uint8
3-4* Ramp 1
3-41
Ramp 1 Ramp Up Time ExpressionLimit All set-ups TRUE -2 Uint32
3-42 Ramp 1 Ramp Down Time ExpressionLimit All set-ups TRUE -2 Uint32
3-5* Ramp 2
3-51
Ramp 2 Ramp Up Time ExpressionLimit All set-ups TRUE -2 Uint32
3-52 Ramp 2 Ramp Down Time ExpressionLimit All set-ups TRUE -2 Uint32
3-8* Other Ramps
3-80
Jog Ramp Time ExpressionLimit All set-ups TRUE -2 Uint32
3-81 Quick Stop Ramp Time ExpressionLimit 1 set-up TRUE -2 Uint32
Table 5.6
Parameter Lists
VLT
®
HVAC Basic Drive Programming Guide
MG18B222 - VLT
®
is a registered Danfoss trademark 5-5
5 5