VLT
®
FCM Series
Programming
317 Time out
(LIVE ZERO TIME OUT)
Value:
1 - 99 sec.
[1 - 99]
✭
10 sec.
[10]
Function:
If the value of the reference signal connected to
the input, terminal 1, falls below 50% of the setting
in parameter 336 for a period longer than the
time set in parameter 317, the function selected
in parameter 318 will be activated.
Description of choice:
Set the desired time.
318 Function after time out
(LIVE ZERO FUNCT.)
Value:
✭
Off (OFF)
[0]
Stop and trip (STOP AND TRIP)
[5]
Function:
This parameter allows a choice of the function to
be activated if the value of the reference signal
connected to the input, terminal 1, falls below 50%
of the setting in parameter 336 for a period longer
than the time set in parameter 317.
If a time-out function (parameter 318) occurs at the
same time as a bus time-out function (parameter 514),
the time-out function (parameter 318) will be activated.
323 Terminal X102, relay function (RELAY FUNC.)
Settings:
✭
No function
(NO OPERATION)
[0]
Ready signal
(UNIT READY)
[1]
Enable, no warning
(ENABLE/NO WARNING)
[2]
Running
(MOTOR RUNNING)
[3]
Running, no warning
(RUNNING NO WARNING)
[4]
Running on reference, no warning
(RUNNING ON REFERENCE)
[5]
Fault
(FAULT)
[6]
Fault or warning
(FAULT OR WARNING)
[7]
Current limit
(CURRENT LIMIT)
[8]
Thermal warning
(THERMAL WARNING)
[9]
Reversing
(REVERSE)
[10]
Control word bit 11
(CONTROL WORD BIT 11)
[11]
Control word bit 12
(CONTROL WORD BIT 12)
[12]
Mechanical brake
(MECHANICAL BRAKE)
[20]
The relay output can be used to give the
present status or a warning.
Relay
1 - 3 break, 1 - 2 make
Max. 250 V AC, 5Amp.
Description of choice:
Unit Ready signal
, the FC motor is ready for use.
Enable/no warning,
the FC motor is ready for
use; no start or stop command has been given
(start/ disable). No warning.
Motor Running,
the output frequency is higher than
0.1 Hz. A start command has been given.
Running no warning,
the output frequency is higher than
0.1 Hz. A start command has been given. No warning.
Running on reference,
no warning, speed according
to reference. No warning.
Fault,
output is activated by alarm.
Fault or warning
, the output is activated by
alarm or warning.
Current limit
, the current limit in parameter
221 has been exceeded.
Thermal warning,
above the temperature limit
in the frequency converter.
✭
= factory setting. () = display text [] = value for use in communication via serial communication port
MG.03.H3.02 - VLT is a registered Danfoss trademark
51