30-50 Heat Sink Fan Mode
Option:
Function:
the frequency converter. This option
represents the classic operating behavior of
fans.
[1] Reduced
Acoustics
[2] Standard
[3] Cooler
Operation
3.22.5 30-8* Compatibility (I)
30-80 d-axis Inductance (Ld)
Range:
Function:
Size
related
*
[0.000 -
1000.000 mH]
Enter the value of the d-axis
inductance. Obtain the value from
the permanent magnet motor
datasheet. The d-axis inductance
cannot be found by performing an
AMA.
30-81 Brake Resistor (ohm)
Range:
Function:
Size
related
*
[ 0.01 -
65535.00
Ohm]
Set the brake resistor value in
Ω
. This
value is used for monitoring the power
to the brake resistor in
parameter 2-13 Brake Power Monitoring
This parameter is only active in
frequency converters with an integral
dynamic brake.
30-83 Speed PID Proportional Gain
Range:
Function:
Size related
*
[0 - 1 ] Enter the speed controller proportional
gain. Quick control is obtained at high
amplification. However, if amplification is
too great, the process may become
unstable.
30-84 Process PID Proportional Gain
Range:
Function:
Size related
*
[0 - 10 ] Enter the process controller proportional
gain. Quick control is obtained at high
amplification. However, if amplification is
too great, the process may become
unstable.
30-85 Motor Frequency
Range:
Function:
50
*
[20 - 1000 Hz]
NOTICE
Changing this parameter affects the
settings of other parameters.
30-85 Motor Frequency
Range:
Function:
Select the motor frequency value from the
motor nameplate data.
Parameters for configuring the wireless LCP 103.
30-90 SSID
Range:
Function:
Size
related
*
[1 -
32 ]
Enter the wireless network name (SSID). The
default value is: Danfoss_<Serial number of
the frequency converter>. The serial number
is in
parameter 15-51 Frequency Converter
.
30-91 Channel
Range:
Function:
5
*
[1 -
11 ]
Enter the wireless channel number. The default
channel number is 5. Change the channel number,
if there is an interference from other wireless
networks. Recommended channels:
USA territory: 1, 6, 11.
Europe: 1, 7, 13.
30-92 Password
Range:
Function:
Size related
*
[8 - 48 ] Enter the wireless network password.
Password length: 8–48 characters.
30-97 Wifi Timeout Action
Select which action to execute if a local reference (hand-on
mode) or a remote reference (auto-on mode) is set via the
wireless connection and the connection is lost.
Option:
Function:
[0]
*
Do Nothing
The frequency converter does
not do any extra actions.
[1]
Stop Motor
The frequency converter
stops the motor (if the motor
was started via a wireless
connection).
3.23 Parameters: 31-** Bypass Option
31-00 Bypass Mode
Select operating mode of bypass.
Option:
Function:
[0]
*
Drive
Motor is operated by drive.
[1]
Bypass Motor is operated at full speed during bypass
mode.
31-01 Bypass Start Time Delay
Range:
Function:
30 s
*
[0 - 60 s]
Parameter Descriptions
Programming Guide
MG33MP02
Danfoss A/S © 10/2018 All rights reserved.
235
3
3
Summary of Contents for VLT AutomationDrive FC 302
Page 2: ......