4.17 Parameters: 18-** Data Readouts 2
4.17.1 18-8* Center Winder Readout
18-81 Tension PID Output
Range:
Function:
0 Hz
*
[-5000 - 5000 Hz] Read only parameter used to show
the output of the tension loop PID.
18-82 Center Winder Output
Range:
Function:
0 Hz
*
[-5000 - 5000 Hz] Read only parameter used to display
the output of the tension loop PID.
18-83 Line Speed
Range:
Function:
0 Hz
*
[-5000 - 5000 Hz] Read only parameter used to display
the output of the tension loop PID.
18-84 Diameter
Range:
Function:
0 %
*
[0 - 100 %] Read only parameter that is used to display
the diameter of the roll.
18-85 Tapered Tension Set Point
Range:
Function:
0 %
*
[0 - 100 %] Read only parameter used to display the
tapered tension set point.
18-86 Tension Feedback
Range:
Function:
0 %
*
[0 - 100 %] Read only parameter used to display the
actual tension feedback.
4.17.2 18-9* PID Readouts
18-90 Process PID Error
Range:
Function:
0 %
*
[-200 - 200 %] Gives the present error value used by the
process PID controller.
18-91 Process PID Output
Range:
Function:
0 %
*
[-200 - 200 %] Gives the present raw output value from
the process PID controller.
18-92 Process PID Clamped Output
Range:
Function:
0 %
*
[-200 - 200 %] Gives the present output value from the
process PID controller after the clamp
limits have been observed.
18-93 Process PID Gain Scaled Output
Range:
Function:
0 %
*
[-200 -
200 %]
Gives the present output value from the
process PID controller after the clamp
limits have been observed and the
resulting value has been gain scaled.
Parameter Descriptions
Programming Guide
MG06C602
Danfoss A/S © 7/2015 All rights reserved.
107
4
4
