VLT
®
6000 HVAC
Programming
■
Quick Menu
The QUICK MENU key gives access to 12 of the
most important setup parameters of the drive. After
programming, the drive will, in many cases, be ready
for operation. The 12 Quick Menu parameters are
shown in the table below. A complete description
of the function is given in the parameter
sections of this manual.
Quick Menu
Parameter
Description
Item Number
Name
1
001 Language
Selects language used for all displays.
2
102 Motor Power
Sets output characteristics of drive based on kW size
of motor.
3
103 Motor Voltage
Sets output characteristics of drive based on voltage
of motor.
4
104 Motor Frequency
Sets output characteristics of drive based on nominal
frequency of motor. This is typically equal to line
frequency.
5
105 Motor Current
Sets output characteristics of drive based on nominal
current in amps of motor.
6
106 Motor Nominal Speed
Sets output characteristics of drive based on nominal
full load speed of motor.
7
201 Minimum Frequency
Sets minimum controlled frequency at which motor
will run.
8
202 Maximum Frequency
Sets maximum controlled frequency at which motor
will run.
9
206 Ramp Up Time
Sets time to accelerate motor from 0 Hz to nominal
motor frequency set in Quick Menu Item 4.
10
207 Ramp Down Time
Sets time to decelerate motor from nominal motor
frequency set in Quick Menu Item 4 to 0 Hz.
11
323 Relay 1 Function
Sets function of high voltage Form C relay.
12
326 Relay 2 Function
Sets function of low voltage Form A relay.
MG.60.C7.02 - VLT is a registered Danfoss trademark
23
