Danfoss VACON NX, Application Manual

Page: 172 / 360

•
•
•
•
P3.4 (Basic Application, Standard Application, Local/Remote Control Application, Multi-Step Speed Control Application, PID
Control Application, Multi-Purpose Control Application)
P3.6
(Pump and Fan Control Application)
Use this parameter to enable the stop button on the keypad.
To make the Stop button a "hotspot" which always stops the drive regardless of the selected control place, give this parameter the
value 1.
See also parameter
ID 125 .
10.15 (ID 117) I/O Frequency Reference Selection
Location in the menu:
P2.14 (Basic Application)
P2.1.11 (Standard Application, Local/Remote Control Application, Multi-Step Speed Control Application, Multi-Purpose Control
Application)
Use this parameter to select the reference source when the control place is I/O A.
Selection
number
Applications:
Basic Application
Standard Application
Local/Remote Control Application
Multi-Step Speed Control Application Applications:
Multi-Purpose Control Application
0 Analog input 1 (AI1) Analog input 1 (AI1). See ID 377.
1 Analog input 2 (AI2). Analog input 2 (AI2). See ID 388.
2
Keypad reference (Menu M3 )
AI1+AI2
3 Fieldbus reference AI1–AI2
4 Potentiometer reference (Local/Remote
Control Application only) AI2–AI1
5 - AI1*AI2
6 - AI1 joystick
7 - AI2 joystick
8 - Keypad reference (Menu M3 )
9 - Fieldbus reference
10 - Potentiometer reference; controlled with ID 418 (TRUE=increase)
and ID 417 (TRUE=decrease).
11 - AI1 or AI2, whichever is lower.
12 - AI1 or AI2, whichever is greater.
13 - Max. frequency (recommended in torque control only)
14 - AI1/AI2 selection, see ID 422.
15 - Encoder 1 (AI input C.1)
16 - Encoder 2 (With OPTA7 Speed Synchronization, VACON
®
NXP only)
(AI input C.3)
10.16 (ID 118) PID Controller Gain
Location in the menu: P2.1.12 (PID Control Application and Pump and Fan Control Application)
AB296635287482en-000301 / DPD00903 172 | Danfoss A/S © 2023.02
Parameter Descriptions
VACON® NX All-in-One
Application Guide