This monitoring value shows the status of the Status Word of the Follower drive.
9.105 (ID 1604) Status Word D4
Location in the menu:
V1.23.4.4
(Multi-Purpose Control Application in VACON
®
NXP only)
This monitoring value shows the status of the Status Word of the Follower drive.
9.106 (ID 1605) Motor Current D2
Location in the menu:
V1.23.3.2
(Multi-Purpose Control Application in VACON
®
NXP only)
This monitoring value shows the measured current of the motor.
9.107 (ID 1606) Motor Current D3
Location in the menu:
V1.23.3.3
(Multi-Purpose Control Application in VACON
®
NXP only)
This monitoring value shows the measured current of the motor.
9.108 (ID 1607) Motor Current D4
Location in the menu:
V1.23.3.4
(Multi-Purpose Control Application in VACON
®
NXP only)
This monitoring value shows the measured current of the motor.
9.109 (ID 1608) Not Ready Cause
Location in the menu:
V1.21.28
(Multi-Purpose Control Application in VACON
®
NXP only)
This monitoring value shows why the drive is not ready.
Table 111: Not Ready Cause
Bit
Signal
b0
Fault is Active
b1
Prevent MC Ready is set
b2
Charge switch is open
b3
DC Voltage not OK
b4
Power unit state not OK
b5
Start-up Wizard is active
b6
Run Enable is not set
b7
Ready state prevented by STO
b8
-
b9
-
b10
-
b11
-
b12
-
b13
-
b14
-
b15
-
9.110 (ID 1609) Prevent MC Ready
Location in the menu:
V1.21.29
(Multi-Purpose Control Application in VACON
®
NXP only)
AB296635287482en-000301 / DPD00903 | 161
Danfoss A/S © 2023.02
Monitoring Value Descriptions
VACON® NX All-in-One
Application Guide
Summary of Contents for VACON NX
Page 1: ...Application Guide VACON NX All in One drives danfoss com...
Page 2: ......
