Procedure for EMC Jumpers 2 + 3, MR9A and MR9B
1.
Remove the cover of the extension box, the touch shield, and the I/O plate with the I/O grommet plate.
2.
Find the 2 EMC jumpers on the EMC board. They are not next to each other. Remove the EMC jumpers.
A
e3
0b
h3
78
.1
0
A
The EMC jumpers
Illustration 18: EMC Jumpers 2 and 3, MR9A and MR9B
3.
Attach the I/O plate with the I/O grommet plate, the touch shield, and the cover of the extension box.
4.
Close the cover of the AC drive.
5.
After the change, write "The EMC level was changed" and the date on the "product modified" label. If the label is not yet attached,
attach it on the drive near the nameplate.
e
3
0
b
g
7
7
3
.1
0
Product modified
Date:
Date:
Date:
6.7 Installation in a Marine Environment
When you install the AC drive in a marine environment, see the Marine Installation Guide.
Electrical Installation
Operating Guide | VACON® 100 Wall-mounted Drives
AQ298036140958en-000101 / DPD01711| 63
Danfoss A/S © 2019.05
Summary of Contents for VACON 100 flow
Page 2: ......