114 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
Front Bearing Power and Sensor Feed Through Installation:
1. Verify all contact surfaces are clean and dry. If not, clean with a lint-free cloth.
2. Apply Super-O-Lube to the new feed through O-rings and then fit them into the O-ring grooves.
3. Carefully insert both feed throughs into the housing. Reconnect the internal connectors.
Figure 145 - Front Bearing
Sensor Feed Through
Figure 146 - Front Bearing
Power Feed Through
Notch
Notch
4. Install a new internal cable tie to secure the bearing sensor feed through cable.
5. Install the eight (8) M5x20 feed through screws and tighten in a crisscross pattern in two (2)
stages:
• Stage 1: Tighten to 3 Nm (26 in.lb.)
• Stage 2: Tighten to a final torque of 6 Nm (53 in.lb.)
Summary of Contents for Turbocor VTT Series
