Danfoss MP20 Series, User Manual

Page: 13 / 16

Receiver icon troubleshooting
Icon Description Action
Power failure Check the receiver power supply
Hardware error Contact distributor; replace receiver
CAN error Contact your distributor
Repose state due to active stop Release stop button and turn transmitter on
Repose state due to passive stop Reestablish link to activate the transmitter
Linked state Correct link
Correct ID (link quality as indicated by the bar) In case of no signal, check if the transmitter is turned on
Incorrect ID In case of interference, change frequency channel
RF signal detected In case of interference, change frequency channel
Mask error Contact your distributor
User Manual
MP20V Receiver
Troubleshooting
© Danfoss | January 2019 BC292570533618en-000101 | 13