PaGE 30
© 2015 OJ Electronics A/S
In this mode, the thermostat operates as a regulator and no sensors are used.
The setting is a percentage of the full load in steps of 10%.
Note that Floor Protection is not active when using the thermostat as a regulator.
Regulator mode is activated under
menu/Installer settings/sensor application/
Regulator
note: Regulator mode is not available with software version 1012n100.
1. Day and time.
2. Measured temperature (if available).
3. Heating indicator. If visible, the underfloor heating system is currently active.
4. Tap here to access the menu.
5. Current target percentage of full load/setpoint.
6. Tap here to increase percentage of full load/setpoint.
7. Tap here to decrease percentage of full load/setpoint.
9.3 Regulator Mode
1
2
3
4
5
6
7
>
<
Contents
