10 Decommissioning and Disposal
10.1 Decommissioning
The procedure for decommissioning the encoder box is
the reverse of the installation procedure described in
chapter
.
Proceed as follows:
•
Disconnect the power supply and wait for the
discharge time to elapse.
10.2 Dismounting
The procedure for dismounting the servomotor is the
reverse of the fitting procedure described in chapter
.
Proceed as follows:
1.
Disconnect the power supply and wait for the
discharge time to elapse.
2.
Disconnect the electrical cables.
3.
Dismount the encoder box.
10.3 Recycling and Disposal
10.3.1 Recycling
Take metals and plastics to recycling stations.
The entire encoder box is classified as electronic waste,
and the packaging is classified as packaging waste.
10.3.2 Disposal
Devices containing electronic components cannot be
disposed of as normal domestic waste.
Dispose of the encoder box as hazardous waste, electrical
waste, recyclable waste, etc. in accordance with applicable
local regulations.
Decommissioning and Disposa...
VLT
®
ISD Encoder Box Operating Instructions
MG75F102 - VLT
®
is a registered Danfoss trademark
29
10
10