Symbols used in Danfoss literature
WARNING may result in injury
Tip, helpful suggestion
CAUTION may result in damage to product or
property
Lubricate with hydraulic fluid
Reusable part
Apply grease / petroleum jelly
Non-reusable part, use a new part
Apply locking compound
Non-removable item
Inspect for wear or damage
Option - either part may exist
Clean area or part
Superseded - parts are not interchangeable
Be careful not to scratch or damage
Measurement required
Note correct orientation
Flatness specification
Mark orientation for reinstallation
Parallelism specification
Torque specification
External hex head
Press in - press fit
Internal hex head
Pull out with tool – press fit
Torx head
Cover splines with installation sleeve
O-ring boss port
Pressure measurement/gauge location or
specification
The symbols above appear in the illustrations and text of this manual. They are intended to communicate
helpful information at the point where it is most useful to the reader. In most instances, the appearance
of the symbol itself denotes its meaning. The legend above defines each symbol and explains its purpose.
Repair Instructions
H1 45/53/60/68 Closed Circuit Axial Piston Pumps
Introduction
520L0957 • Rev CB • September 2014
7
