FC 300 Instruction Manual
How to Install
"
Motor connection
NOTE
Motor cable must be shielded/armoured. If
an unshielded/unarmoured cable is used,
some EMC requirements are not complied
with. For more information, see
EMC specifications
in the
VLT AutomationDrive FC 300 Design Guide
.
1.
Fasten decoupling plate to the bottom of FC 300
with screws and washers from the accessory bag.
2.
Attach motor cable to terminals 96 (U),
97 (V), 98 (W).
3.
Connect to ground connection (terminal
99) on decoupling plate with screws from
the accessory bag.
4.
Insert terminals 96 (U), 97 (V), 98 (W) and
motor cable to terminals labelled MOTOR.
5.
Fasten shielded cable to decoupling plate with
screws and washers from the accessory bag.
16
MG.33.A4.22 - VLT is a registered Danfoss trademark
