FC 300 Profibus
Introduction
Assumptions
This manual assumes you are using a DANFOSS PROFIBUS Option Card in conjunction with a DANFOSS
FC300 Series. It is also assumed that your master is a PLC or PC equipped with a serial communication card
supporting all the PROFIBUS communication services required by your application, and that all requirements
stipulated in the PROFIBUS standard, as well as those set up in the PROFIBUS Variable Speed Drive Profile
and its company-specific implementation PROFIdrive, as well as those pertaining to the VLT Variable Speed
Drive are strictly observed as well as all limitations therein fully respected.
Hardware
These Operating Instructions relate to the Profibus fieldbus option type no. 130B1100 and type no.
130B1200.
Background Knowledge
The DANFOSS PROFIBUS Option Card is designed to communicate with any master complying with the
PROFIBUS standard. Familiarity with the PC or PLC you intend to use as a master in your system is assumed.
Issues regarding hardware or software produced by other manufacturers are beyond the scope of this
manual, and are not the responsibility of DANFOSS.
If you have questions regarding set-up of master-to-master communication, or communication to a
non-Danfoss slave, please consult the appropriate manuals
FC 300-related Literature
The following literature is available for the FC 300 series.
Title
Literature no.
FC 300 Operating Instructions
MG.33.AX.YY
FC 300 Design Guide
MG.33.BX.YY
FC 300 PROFIBUS Operating Instructions
MG.33.CX.YY
FC 300 DeviceNet Operating Instructions
MG.33.DX.YY
FC 300 MCT 10 Software Dialogue
MG.33.EX.YY
PROFIBUS DP V1 Design Guide
MG.90.EX.YY
Please also refer to
www.danfoss.com/drives
for frequently asked questions and additional information.
11
MG.33.C2.02 - VLT is a registered Danfoss trademark
