Risk of squeezing
There is a risk of squeezing on the moving parts.
Tilting hazard
The risk of tilting mainly exists while the machine is being trans-
ported.
•
Observe the machine's centre of gravity during transport.
2.3.2 Risks imposed by electricity
There is a risk of electrocution near the live parts!
•
Work on electric systems may only be performed by qualified
electricians or instructed and trained persons under the supervi-
sion of a qualified electrician.
•
Deactivate the machine/unit and secure it against unintentional
restart before maintenance.
2.3.3 Risks imposed by noise
The noise level meter acc. to IEC 804, Class 2, was calibrated before
measuring.
The operation of the machine causes noise emissions of 80 dB(A) at
the workplace. Noise protection is required.
Higher noise emissions may occur when other machinery is simulta-
neously used at the workplace. The machine owner must provide for
appropriate protection, e.g.
•
instruct staff to wear ear protection;
•
provide information/instructions on risks
•
identify hazardous areas
•
provide health monitoring
2.3.4 Risks in case of fire
The operating staff has to be familiar with the location as well as with
operating the fire alarm and fighting means. Free access to this
equipment must be ensured.
Summary of Contents for ET9400
