Danfoss ET5070, Operator'S Manual, Page: 62 / 96

After replacement of the slide bearing plates, the machine has to
be recalibrated (see CONTROL C.2 / IPC Operation Manual).
6.5 Installation of spring-mounted pressure piece in intermediate
dies
The intermediate die 237.239.2L2 (1) has to pin holes. For using the
second pin hole, an additional spring-mounted pressure piece (4) has
to be mounted in the intermediate dies:
1. Remove the intermediate die from the machine.
2. Insert a pressure piece (4) in the hole (3) and screw it in by
twelve revolutions.
3. Press the crimping dies (2) into the locating hole with the newly
mounted pressure piece.
Only screw in the pressure piece until the crimping dies cannot be
moved manually any longer. If the pressure pieces are tightened
excessively, the pins will be subject to excessive wear.