Danfoss ET5070, Operator'S Manual, Page: 48 / 96

ATTENTION!
Risk of damage to machinery!
If the crimping dies protrude beyond the basic and intermediate
dies, the crimping dies, the intermediate dies and the machine
will be damaged (see (X) in the figure). In the figure, the crimping
die (2) is placed incorrectly.
•
Place the crimping die (2) in the base and/or intermediate die
(3) so that it does not protrude.
In the figure, the crimping die (1) is placed correctly.
5.5 Adjusting the depth stop
The depth stop must be adjusted specifically for the work piece.
When inserting the hose, the crimping process is triggered by contact
with the stop disc. When the pre-defined forming diameter or forming
pressure is reached, the tool will stop automatically. Remove depth
stop for special applications, e.g. pipe bends.