Danfoss ET5070, Operator'S Manual, Page: 44 / 96

4. Manual operation mode: Press the button to open the ma-
chine when the forming process is completed.
5. Semi-automatic operation mode: Wait until the hold time defi-
ned in the control has expired; the tool will then open automati-
cally.
6. Remove the workpiece from the tool.
7. Check the forming dimension after the first forming process.
Correct the forming dimension in case of deviations between the
actual dimension and the specified dimension (see "Setting the
forming dimension" in Section 5).
The Automatic External mode with the depth stop is only functional
if the connection of the depth stop is established in the control ca-
binet.
5.4 Changing the crimping dies
5.4.1 Changing the crimping dies/intermediate dies with a die key
Positioning the dies
1. Open the crimping tool fully.
2. Deactivate the machine at the power switch.