Danfoss ET5070, Operator'S Manual, Page: 42 / 96

5.3.3 Remote automatic mode, via dual foot switch
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the die and the workpiece.
• Keep the feed opening for the workpiece as small as possi-
ble.
• Keep a minimum distance of 120 mm (A) to the die system.
1. Press the button to activate the dual foot switch.
2. Manually position the pre-mounted workpiece in the tool.
3. Hold the workpiece with one hand during the forming process.
4. Activate and hold the dual foot switch.
5. Manual operation mode: When the forming process is comple-
ted, release the foot switch >Close< and activate the foot switch
>Open< to open the tool.
6. Semi-automatic operation mode: Wait until the hold time defi-
ned in the control has expired; the tool will then open automati-
cally.
7. Remove the workpiece from the tool.
8. Check the forming dimension after the first forming process.
Correct the forming dimension in case of deviations between the