Danfoss ET4500-002, Operator'S Manual

Page: 56 / 96

5.10 Emergency stop
In case of an emergency
Immediately press the emergency-stop button (1) in cases of
emergency. The crimping tool movement will be stopped. The drive
unit is shut down.
Restart after and emergency
WARNING!
Risk of injuries!
The emergency-stop button was probably activated due to the
occurrence of a hazardous situation. A restart of the machine
may cause injuries if the hazardous situation has not yet been
remedied!
• Remedy the hazardous situation before a restart.
1. Remedy the cause of the emergency stop.
2. Unlock the emergency-stop button.
3. Reset the error messages on the control.
5.11 Cleaning
ATTENTION!
Risk of damage to machinery!
If the machine is cleaned with a steam jet or compressed air, dirt
and water may ingress in the machine and cause serious da-
mage.
• Do not use a steam jet to clean the machine.
• Do not use compressed air to clean the machine.