The micrometer (7) is used to change the final diameter of the die
system.
Crimping tool
The die system comprises base dies, intermediate dies (depending
on the application) and crimping dies.
All base dies are mounted on slide plates. The crimping dies and
the intermediate dies, if present, are attached to the base dies (1).
The intermediate dies are required if small work pieces are to be
formed on a large machine.
After the forming process, the base dies are pressed apart by the
pressure springs (2) when the tool opens. The bearing segments
(3) on the front guide the base dies axially in the tool.
3.2 Accessories
The machine may be fitted with accessories. A list of the available
accessories is included in the Annex, Section "Accessories".
Summary of Contents for ET4400
