IK4 start up
Use the information below to properly turn the transmitter ON (OPERATION mode).
1.
Place a charged battery in the transmitter. The charge must be done following the instructions of the
Battery Chargers' Manual.
2.
Turn the contact key.
1
FUDQH[[
0
1
0
1
>ƉƵůƐĞ
ĚŝƐƉůĂLJŽƉ
௭
ŽŶ
>ƉƵůƐĞ
3.
Push and pull out the STOP button.
LED will flash orange-green pulse. If the transmitter has LCD, it displays the identification of the
machine and battery level (only if it has been pre-programmed).
FUDQH[[
>ƉƵůƐĞ
ŝƐƉůĂLJŽƉƚŝŽŶ
4.
Press the start button. The green LED will now light to indicate the transmitter is transmitting. Once
the Tx is connected, press any maneuver button and its corresponding relay will be activated. Check
to make sure all other maneuvers work in a coherent way with the expected movements.
1
FUDQH[[
0
1
0
1
>ƉƵůƐĞ
ĚŝƐƉůĂLJŽƉ
௭
ŽŶ
>ƉƵůƐĞ
User Manual
IK4 Transmitter
Technical description
Danfoss | February 2019
BC290863558440en-000101 | 7
IK4 start up
Use the information below to properly turn the transmitter ON (OPERATION mode).
1.
Place a charged battery in the transmitter. The charge must be done following the instructions of the
Battery Chargers' Manual.
2.
Turn the contact key.
1
FUDQH[[
0
1
0
1
>ƉƵůƐĞ
ĚŝƐƉůĂLJŽƉ
௭
ŽŶ
>ƉƵůƐĞ
3.
Push and pull out the STOP button.
LED will flash orange-green pulse. If the transmitter has LCD, it displays the identification of the
machine and battery level (only if it has been pre-programmed).
FUDQH[[
>ƉƵůƐĞ
ŝƐƉůĂLJŽƉƚŝŽŶ
4.
Press the start button. The green LED will now light to indicate the transmitter is transmitting. Once
the Tx is connected, press any maneuver button and its corresponding relay will be activated. Check
to make sure all other maneuvers work in a coherent way with the expected movements.
1
FUDQH[[
0
1
0
1
>ƉƵůƐĞ
ĚŝƐƉůĂLJŽƉ
௭
ŽŶ
>ƉƵůƐĞ
User Manual
IK4 Transmitter
Technical description
Danfoss | February 2019
BC290863558440en-000101 | 7
DANFOSS BT27IK
