d&b audiotechnik Y Series, Manual

Page: 6 / 12

2.2 Connections
The cabinets are fitted with a pair of NLT4 F/M connectors. All
four pins of both connectors are wired in parallel. The Y8 and Y12
loudspeakers use the pin assignments 1+/1–. Pins 2+/2– are
designated to actively driven subwoofers. Using the male
connector as the input, the female connector allows for direct
connection to a second cabinet.
The cabinets can be supplied with NL4 M or EP5 connectors as an
option.
Pin equivalents of the connector options are listed in the table
below.
NLT4 F/M
NL4 M
1+ 1– 2+ 2– n.a.
EP5
1 2 3 4 5
d&b LoadMatch
Starting with the D80 amplifier platform, the LoadMatch function
enables the amplifier to electrically compensate for the properties
of the loudspeaker cable used without the need for an additional
sense wire. For applicable loudspeakers, LoadMatch is therefore
independent of the connector type used.
2.3 Operation
NOTICE!
Only operate d&b loudspeakers with a correctly configured d&b
amplifier, otherwise there is a risk of damaging the loudspeaker
components.
Applicable d&b amplifiers:
D80/D20/D12/D6/10D/30D.
Application Setup Cabinets per
channel
Y8 Y8 Arc/Y8 Line 2
Y12 Y12 Arc/Y12 Line 2
The applicable d&b amplifiers provide two setups ("Arc" or "Line")
for the Y8 and Y12 loudspeakers. These are available in Dual
Channel or Mix TOP/SUB mode.
Arc and Line setups
The selection of Arc or Line depends on the curvature of the array.
Both setups may be used within one array.
The Arc setup is intended for line array loudspeakers when used in
curved array sections.
The Line setup is used for long throw array sections with three or
more consecutive splay settings of 0°, 1° or 2°. Compared to the
Arc setup, the mid/high range is reduced to compensate for the
extended nearfield.
passi ve
crossover
Connector wiring
d&b Y8/Y12 Manual 1.2 en 6