V-Series arrays and assembly
3.4 Ground stacks
警告!
怪我や機器損傷の恐れがあります！
グランドスタックを組み立てる際は、動いたり転倒しない
ように常に固定してください 。
最大キャビネット 数に注意してください 。これは特に、混
合グランドスタックにおいて 非常に重要です。
3.4.1 V8/V12 ground stack
Limitations
A maximum of 8 x TOP cabinets with the V フライングフレーム
serving as ground support are allowed to be set up as ground
stack.
Preparations
In this type of setup the V フライングフレーム is used as
ground support.
For this purpose, the Splay link of the frame must be removed and
stored in a safe place.
The Locking pin of the Cable pick will be used to fix the vertical
aiming of the first TOP cabinet on the Flying frame at a later stage.
For this reason, the Cable pick assembly (O-ring) must be attached
to hole 35 of the Frame's hole grid.
Proceed as follows:
1. Prepare the Flying frame
To attach the TOP cabinets to the Flying frame, the two additional
Front links of the frame are required.
1. Remove the additional Front links together with their Locking
pins from the park position on the frame.
2. Attach the additional Front links at the top of the front tracks of
the frame and fix them using one Locking pin.
Þ
Observe the direction of attachment as shown in the
graphic opposite.
2. Change the position of the Cable pick
1. Release and remove the Locking pin of the Cable pick.
2. Unlock and remove the ring cotter of the fixing bolt.
3. Pull out the fixing bolt and take off the O-ring.
4. Attach the O-ring to its new position (hole 35) and insert the
fixing bolt.
5. Reinsert the ring cotter to secure the fixing bolt and ensure the
ring cotter is properly locked.
Splay link removed and Cable pick attached to hole 35.
d&b V-Series リギングマニュアル 1.11 ja
33
