LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example, in a wet basement or near a sink.
• This appliance is intended for indoor household
use only. It is not designed for outside
installation, including anywhere that is not
temperature controlled (garages, porches,
vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 63.4 cm (25 inches) wide
by 84 cm (33.1 inches) high by 56.4 cm
(22.2 inches) deep. Make sure that you leave
the minimum amount of space between the
appliance and all surrounding walls and vents.
• Allow 12.7 cm (5 inches) of space between the
back and sides of the appliance and all adjacent
walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
FEATURES
1. Thermostat Dial
2. Defrost Drain
3. Leveling Legs
4. Rust Resistant Interior
(not pictured)
3
IMPORTANT NOTE
The freezer lid may be diffi cult to open immediately
after closing it. This is normal and is due to the
pressure difference between the cold interior of the
freezer and the warm air that has just entered the
freezer when the lid was opened. The pressure will
equalize within a few minutes.
If the lid is especially diffi cult to open, wait 5
minutes to allow the pressure to equalize and then
try again.
INSTALLATION INSTRUCTIONS
OPERATING INSTRUCTIONS
R
2
1
3
