Danaher Motion
05/2008
Installation
S200-CNS Product Manual
25
6 INSTALLATION
6.1 U
NPACKING AND
I
NSPECTING
Open the box and remove all the contents. Check to ensure there is no visible damage to any of the
equipment.
CAUTION
Use proper procedures when handling electronic components
to avoid damage to equipment.
CAUTION
Remove all packing material and equipment from the shipping
container. Be aware that some connector kits and other
equipment pieces may be quite small and can be accidentally
discarded. Do not dispose of shipping materials until the
packing list has been checked.
NOTE
Upon receipt of the equipment, inspect components to ensure
that no damage has occurred in shipment. If damage is
detected, notify the carrier immediately. Check all shipping
material for connector kits, documentation, diskettes, CD-
ROM, or other small pieces of equipment.
6.2 M
OUNTING
The S200 drives are designed for operation in a cabinet using the following installation instructions:
•
Mount the drives vertically inside a cabinet on a flat, solid, electrically conductive, mounting
surface connected to PE (protective earth ground) and capable of supporting the weight of the
unit.
•
Provide a good connection to PE. Remove the paint on the mounting surface over an area
extending at least 12 mm (0.5 in) from the mounting bolts to achieve good electrical connection
over a large area between the drive and grounded mounting surface.
•
Ensure the environment within the cabinet meets the requirements listed in the environmental
specifications table.