Danaher Motion
04/06
Appendix A
APPENDIX A
A.1
R
EGULATORY
I
NFORMATION
A.1.1
USE CONFORMING REQUIREMENTS
The equipment described herein has been developed, produced, tested and
documented in accordance with the corresponding standards. During use
conforming with requirements, the equipment is not dangerous for people or
equipment. Use conforming with requirements means that the safety
recommendations and warnings detailed in this manual are complied with
and that the applicable regulations for safety (machine directives, etc.) and
noise suppression (EMC Directives) are observed while operating the drive.
At the end of its lifetime, dispose of or recycle the drive according to the
regulations applicable at that time.
A.1.2 CE-APPROVAL
The CE initials confirm that the P70360 drives satisfy all requirements of CE
Directives.
The equipment is not ready to operate without additional installations (cable,
motor, etc.). Thus, all necessary tests and measurements had to be made
on a typical installation. The test installation with all peripheral devices, as
well as the test results and measurements are recorded in detail in
documentation that is available from the manufacturer on request. The test
installation, to which the Declaration of Conformity refers to, is described in
section A.2.1.
Drive CE EMC compliance and machine CE EMC compliance
NOTE
If the connection method on your machine is different
from the one described in section A.2.1, or in the
event of use of components other than those that we
have specified, adherence to CE interference limit
values cannot be guaranteed.
The machine builder should incorporate good EMC
installation and wiring practices in the machine
design. Some machine designs will require more
EMC consideration than others, for example a multi-
axis machine will generate more noise than a single
axis machine therefore it may require the
incorporation of additional noise reduction
techniques.
M-SD-7AC-01 Rev
D
41